Owner`s manual

MAINTAINING YOUR SPA cont...
REMOVING, INSTALLING AND CLEANING FILTERS
Thesearethestepsneededtosuccessfullyreplaceyourlters.
Youshouldreplaceyourdisposablespaltersandcleanyour
nondisposablelterseveryfourmonths.
1) Turn off all power to your spa and remove
thelterlidbyliftingitouttowardsyou.
2)Turntheltercounterclockwiseand
removeitfromthelterwell.
3)Disposeoftheusedlter.
5) To replace, set screen back into its place
and turn clockwise to fasten. DO NOT
over-tighten.
6)Placethenewlterintopositionandturn
clockwise to fasten. DO NOT over-tighten.
7) Follow the directions 1) and 2) for the
pleatedltercartridge.Youthenrinsethe
lterwithagardenhoseandsoakthelter
inamixtureofonepintofltercleaner
with 2.5 gallons of water for at least
12hours.Theltermustbecompletely
submerged. You then follow the directions
5)and6)toreplacethelter
WARNING: Power to your spa must be turned off prior to
removing your lters. The suction at the lter is extremely strong
and can cause injury if there is no lter. NEVER run your spa
without the lters properly installed. Injury to person and damage
to the equipment can occur. Any damage to equipment due to this
circumstance will not be covered under warranty.
27