ENJOY Your QCA Dream Series Spa VS500 Spa Pak OWNER’S MANUAL This owner’s manual is for YOU! It will show you how to operate and maintain your very own spa. We think it is important for you to take a few moments and get acquainted with your new spa operation. Please keep this manual available for references. QCA Spas would like to congratulate you on your purchase and we sincerely hope you enjoy your QCA Spa. SERIAL NUMBER _____________ 18 DIGIT SPA NUMBER ____________ DreamSeriesManual VS500.501 1.
. TABLE OF CONTENTS Cleaning the Filter Cartridge ............................................................................ 8 Diagnostic Messages ......................................................................................... 6 Draining the Water ............................................................................................ 7 Filter Maintenance ............................................................................................. 8 Hyperthermia Description ...............
UL INSTRUCTIONS b. Since excessive water temperatures have a high potential for causing fetal damage during the early months of pregnancy. Pregnant or possibly pregnant women should limit spa or hot tub water temperatures to 100°F (38°C). The instructions that you are about to read, are required by Underwriters Laboratories to be published in your manual. These instructions are very important for your safety and QCA would like to encourage you to read and apply all instructions. Thank you. c.
Spa Location Installation Instructions The selection of a site for the installation of your spa is a very important decision and should be undertaken keeping several factors in mind. Electrical-General Prior to performing any service to the spa package turn OFF ALL primary electric power at the main circuit breaker or disconnect panel. Opening the front cover of the electrical control box can make all field electrical connections. 1. Always check your local codes before installing your spa.
YOUR • QCA • SPA • EQUIPMENT Dream Series Control When your spa is first powered up, it will go into Priming Mode, indicated by “Pr”. Priming mode will last for 5 minutes and then the spa will being to heat the spa and maintain water temperature in the Standard Mode. During this cycle do not press any buttons as it will cause the priming mode to start over. off after 15 minutes. The low speed of the pump runs when the blower is on.
Diagnostic Messages Message Meaning No message on display. Power has been cut off to the Spa. -Temperature unknown. Action Required The control panel will be disabled until power returns. After the pump has been running for 2 minutes, the temperature will be displayed. Spa is powering up. This operation takes 6 minutes total. After 4 minutes, “- -” will appear for two minutes. The spa then enters it’s first filter cycle and is now available for setting. DO NOT ENTER THE WATER.
your spa equipment pack. A drain fitting is provided on cabinet panel. Remove plug from drain. Attach garden hose to drain adapter and lay out garden hose to the location where water is to be drained. Screw drain adapter into drain fitting spa will automatically drain by gravity. QCA Spa Light All equipment Modules have a receptacle, located on the Equipment Module. This receptacle is provided for the connection of the spa light.
Removing a Box Filter Cartridge The cartridge of the in-line filter must be removed for cleaning. This is accomplished as follows: for box filter Water Care Daily Checklist 1. Test for proper bromine or chlorine level. Proper bromine level should be maintained at 2.0 - 4.0 PPM. 2. Test pH levels and adjust if needed. If you are having difficulty keeping pH properly balanced, it may be an indication that total alkalinity needs adjusting. Have your dealer test the water and adjust if needed.
3. Upon your return, check the level of sanitation of your spa water. If the chlorine test reads "O" and you have been gone an extended period of time, SUPERCHLORINATE the spa water to ensure all organisms and algae are oxidized. Turn the Temperature Control clockwise to return it to the original setting. The spa water will be safe for you to use once the Free Chlorine Residual has below 5.0 PPM.
WARRANTY REGISTRATION This warranty applies to spas manufactured by QCA JEWEL Spas and sold to an original consumer purchaser at retail ("Purchaser") after January 1, 2001. To validate this warranty, the Purchaser must complete the enclosed warranty registration card and mail it to QCA Spas within 30 days of deliver of the spa. RETURN OF THE OWNER REGISTRATION CARD IS A CONDITION OF WARRANTY COVERAGE.
To receive your FREE gift to help maintain your spa and to VALIDATE your spa warranty, return the PREPAID registration card below within the next THIRTY days. To immediately register your new spa; you may log onto our web site at qcaspas.com.
