Owner`s manual

SPA STARTUP DIRECTIONS
All Viking Spas require a solid, flat surface.* This is to ensure that the
spa cabinet is not exposed to a pressure stress condition that may
result in cabinet damage and shell cracking. A concrete pad is the
best example of a solid, flat surface, however, wood decking is suit-
able, provided it can withstand 85# per sq. ft. without deflection.
* FAILURE TO PROVIDE A PROPER, SOLID, FLAT SURFACE
MAY DAMAGE YOUR SPA AND VOID YOUR WARRANTY.
The following procedure should be followed on initial startup and
whenever the spa is drained for maintenance. Read each step in its
entirety before proceeding with that step.
FILL THE SPA WITH WATER
a. Clear all debris from your spa.
b. Using a garden hose, fill the spa with water.
c.
DO NOT use softened water.
d. As water level rises, check inside equipment compartments for
water leaks. It may be necessary to tighten loose unions and/or
fittings.
e. Make sure T-Handled Gate VALVES at pump and heater are open.
(Fully extended up position).
Fill until approximately 6” from top of spa or to water level mark on
face of skimmer opening.
APPLY POWER
a. Apply power by turning on the spa-dedicated circuit breaker.
b.
T
est the GFCI: push the TEST button and power is cut off. Push
RESET and power is restored. If these do not seem to work,
STOP!
Do not use your spa.
Ther
e is no power
, the
21