Owner`s manual

GFCI is defective or the equipment is malfunctioning. Only a

LICENSED ELECTRICIAN should do further inspection.

ACTIVATE WATER PUMP

Press the jet button on the control board. The high-speed pump will

come on.

Press the jet button again to turn the water to low speed.

Check for water leaks at unions and/or fittings on your equipment

while pump is running.

SKIMMER SIDE FILTER

All Viking spas have a skimmer side filter that does not require “air

bleeding” on initial startup. Simply fill spa to proper water level

(approximately half way up on skimmer throat opening) and follow

start-up procedure

Clean spa filters are critical for proper operation. Dirty filters cause

water restriction to the pump, which in turn may cause erratic heating

of the spa. A starving pump will degrade performance, result in dirty

or murky water and may cause the heater to malfunction.

ADD START-UP CHEMICALS

Ask your spa retailer to HELP you set up a chemical maintenance program.

The importance of chemical balance in your spa cannot be overem-

phasized.

SANITIZING: After filling spa, adjust the alkalinity and pH with the

pH increase and pH decrease per label instructions. Once this is com-

pleted, add 2 ounces of granular chlorine directly to the water while

your cir

culating pump is r

unning.

This should complete your star

t-up

ocedur

NOTE:

If you live in an ar

ea wher

e city water is not available, or

your spa water shows signs of calcium content, you will need to add a

“stain n scale” chemical on initial fill and then once a week, thereafter.

1 22