Instructions / Assembly

Unbox your Enkor™ accent planks. For best results, allow Enkor planks to
acclimate to the room conditions prior to installation. Spread out the boxes with
the planks lying at on a solid surface. (Approx. 24 hrs)
UNBOX
ENJOY!
Enkor Interior Wall Accents are intended for indoor applications. For best results,
install horizontal, on wood framed walls covered with drywall.
CUT
Cross cutting to length with a power saw is recommended. We also
recommend you make cuts as you install the planks on the wall to ensure you
have accurate length measurements to minimize unnecessary waste. For your
safety, always cut wood products in a well ventilated area using safety glasses,
a dust mask, and gloves. Be sure to read manufacturer specications and
instructions before operating any power equipment.
If you need to cut the width of the plank we recommend using a circular saw.
Simply measure the area of wall left to cover to get the width measurement, then
cut the plank(s) to match.
Nail each plank to your wall, using 18 gauge, 1-1/2" nails. Nails must be
in a stud. Each plank is designed to span 4 studs, with 2 nails into each stud,
approximately 3/8" away from the edges. Once nailed, make sure each nail is
ush with the decorative wall plank to prevent over nailing or leaving the nail
head raised.
NAIL
INSTALL
We recommend installing planks starting with a full panel and working from
the top of the wall down. Start the rst row from left to right, install the next row
from right to left and continue to alternate directions for each row. The cut o
portion from the previous row should be used to start the next row.
The ends of adjacent planks should meet at the center of a stud for proper
attachment. If there is no baseboard, allow for a small gap between the oor
and the bottom of the rst plank.
ALIGN
Align your planks on the oor to visualize
how your layout will look before you begin
attaching to the wall. Locate the wall studs’
centers and use a light vertical pencil line to
mark the location with a level.
A battery-operated stud nder can help with
this task. Note that studs may not be exactly 16"
or 24" apart especially if there are windows or
other openings in the wall. Locating each stud
will allow you to place board ends over the stud,
so both pieces can be nailed securely to it.
GET STARTED
Time to turn up the tunes and get started. Depending on the exact height of
your space you may need to cut a narrow row of planks to nish the wall.
Determine this by simply measuring your wall from ceiling to oor and divide this
measurement by the width of your Enkor plank. (The decimal amount will be the
part less than a full piece.)
*Enkor pieces measure 5-7/8” (5.875) in height.
Example: Wall Height 96” divided by 5.875 = 16.34
16 (full courses) x 5.875” = 94”
96” - 94” = 2”
You will need 16 full pieces at 5.875” and 1 piece at 2” to complete
If a narrow row of Enkor planks are necessary, we recommend installing planks
starting with a full panel and working from the top of the wall down. Often, the
bottom row will not be visible due to the placement of furniture or trim.
Mark stud locations
16"
oset
16"
oset
16"
oset
Existing
Baseboard Trim
Nail placement