EN-7100 USER MANUAL
Series EN-7100 ***Important-First please check your model number before proceeding. The user manual is set up to correspond to the model number and installation will vary depending on the model. Required tools: Phillips head screwdriver, pliers ***(Photos shown may vary according to model number) Place case on edge of table (Fig.1). With one hand holding top of chassis, pull quickly from the bottom of the bezel to remove it (Fig. 2).
Fig:4 Remove fan housing by using thumbs to unfasten clips and place fan in housing (Fig. 4). Snap fan housing back into the chassis. Connect fan and speaker wiring to M/B as instructed in M/B user manual (After M/B is installed!). Install 3.5" HDD and FDD (floppy) A. Squeeze tabs on side and remove 3.5" drive cassette (Fig. 5). Slide HDD into cassette and fasten with coarse thread flat head screws. Make sure EMI clip is Fig:5 In place. B.
A.Identify if M/B is AT or ATX. B.Remove M/B mounting plate by pulling Latch towards back of chassis and swinging out the plate (Fig. 8). C.Make sure punch out holes for I/O ports on the I/O plate are punched out matching Fig:8 ports on the M/B. D.Install at an angle, first by lining up the I/O ports on the M/B with I/O plate (Fig. 9). E.Once holes are lined up, set M/B on standoffs and stakes, make sure the M/B is seated properly and fasten M/B using hex head screws.
A. Orient top cover and spread sides. Slide vertically down and make sure slide fasteners guides are properly set in the rails. B. Once top cover is set properly on the rails, slide away from you towards backof chassis to close the top cover. Use hex head screws to fasten top cover to chassis. Snap in to place, starting with top snaps. Make sure to line up tabs on top end with the slots in the chassis.
7 2 5 P/S 20 1 17 18 3 10 9 13 3.
Part List EN-7100 NO 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 EN-7100 NO A B C D E F G I SER IES P/N:36132791 P/N PART NAME 3214101 CHASSIS 3214123 5.25” DRIVE BRACKET 5208089 3.5” DRIVE BRACKET 3214112 SUPPORT BRACKET 3214555 ADAPTER BRACKET 3214145 M/B MOUNTING PLATE 3214544 COVER ******* BEZEL 3212514 3.5”EMI CLIP 3132621 M/B LATCH *5405126 FAN AND FAN HOLDER 3132643 CARD GU IDE BRACKET (A.B.