EN-7230 USER MANUAL
Series EN-7230 ***Important-First please check your model number before proceeding. The user manual is set up to correspond to the model number and installation will vary depending on the model. Required tools: Phillips head screwdriver, pliers ***(Photos shown may vary according to model number) Place case on edge of table. (Fig.1) With 1 hand holding top of chassis, pull in quick motion from the bottom of the bezel to remove it (Fig. 2). Be careful not to pull bezel off before hinges are disengaged.
Remove fan housing by using thumbs to unfasten clips and place fan in housing (Fig 5). Snap fan housing back into the chassis. Connect fan and speaker wiring to M/B as instructed in M/B user manual Fig:5 (After M/B is installed!). Install 3.5" HDD and FDD (floppy) A. Squeeze tabs on sides 3.5" drive cassette (Fig.6) and pull out to remove. Slide HDD into cassette and fasten with coarse Fig:6 thread flat head screws. B. Slide floppy into the same cassette and fasten with fine thread flat head screws.
**Depending on M/B, you might have To remove drive cassette** A. Identify if M/B is AT, ATX or microATX. B. Place chassis on its side with electronic Bay in view (Fig. 9) C. Using your choice of standoffs or stakes to fasten M/B, prepare and screw into mounting plate. D. Make sure punch out holes for I/O ports Fig:9 on the I/O plate are punched out matching ports on the M/B. E. Install at an angle, first by lining up the I/O ports on the M/B with I/O plate. (Fig. 10) F.
Three pc. Cover Reinstall top cover making sure to line up tabs on back (Fig.12). Then install side panels by placing on rail guides (Fig.13), and sliding towards back of chassis. Use hex screws to fasten side panels in place. Fig:12 Fig:13 One pc. Cover Fig:14 To replace top cover, spread sides as shown in (Fig. 14). Slide vertically down and make sure slide fasteners guides are properly set in the rails. Once top cover is set properly on the rails, slide away from you to close the top cover.
Snap into place, starting with top snaps.
2 4 1 19 3 Option 3.
Part List EN-7230 SERIES P/N:36110341 NO P/N PART NAME 1 3213698 SUPPORT BRACKET 2 3213665 5.25”DRIVE BRACKET 3 3213643 CHASSIS 4 5207667 ADAPTER BRACKET(BABY AT,ATX) 5 3214577 ADAPTER PLATE 6 3213676 M/B MOUNTING PLATE 7 5208089 3.5”DRIVE BRACKET 8 3213654 COVER 9 3131445 CARD GUIDE BRACKET(A.B.S) 10 5103794 BEZEL(7230 ONLY) 11 5404613 CONTROL CONNECTOR(A) 12 3132596 POWER SWITCH HOLDER 13 3212514 3.
