User's Manual

Page 2
Page 3
Page 4
Step Description
1. Switch off the circuit breaker supplying power to the light.
2 The sensor is designed to mount in a 1-inch hole in the
ceiling tile. This sensor is for use with the Philips XSR driver.
3. Make a small circular cut (one-inch) in the ceiling tile.
Thread the spring arms around the sensor.
4. Measure the distance between the sensor’s installation
location and the LED driver’s “SR connections,”. Cut two
lengths of 18 AWG solid wire that are at least this length
plus one inch. Strip each end of the two wires leaving 3/8
inch of exposed wire.
5. Insert one end of the pair of wires into the LED driver’s “SR
connections” wire holes, (see Figure 5), and pull the other
end through the hole in the tile. See Figure 2.
6. Insert the free end of the pair of wires into the sensor’s wire
hole. See Figure 2.
7. Push the spring arms together and insert the sensor through
the hole in the tile. See Figure 2.
8. Turn the power on by switching on the circuit breaker.
Tile Mount Sensor Installation
Problem Solution
LED not on Check power and wiring
Solid red LED Sensor fault – replace
Red blinking LED Incompatibility between LED driver and
sensor – replace LED driver and if not
resolved, replace sensor
Troubleshooting
Note: For any reason, if you need to remove the two wires,
push down on the tabs located on the rear of the sensor with a
pointed device, and remove the wires while continuing to hold
the tab down.
To Enlighted
sensor
Figure 2: Tile Mount Sensor
Figure 3: Sensor location in a fixture
Fixture Mount Sensor Installation
Step Description
1. Switch off the circuit breaker supplying power to the light.
The sensor is designed to mount in a ½ inch trade size
knockout on a fixture. This sensor is for use with the Philips
XSR driver.
2 Determine the location for the sensor in the fixture and cut
an existing knockout (½ inch) in the fixture. See Figure 3.
3 Insert the compact sensor through the hole in the fixture.
Use the lock nut from behind the sensor to fasten the
compact sensor. See Figure 4.
4. Measure the distance between the sensor’s installation
location and the LED driver’s “SR connections,” and cut
two lengths of 18 AWG solid wire that are at least this
length plus one inch.
5. Strip each end of the two wires leaving 3/8 inch of exposed
wire.
6. Insert one end of the pair of wires in the sensor’s wire holes
and the other end in the LED driver’s “SR connections” wire
holes. See Figure 6.
7. Turn the power on by switching on the circuit
breaker.
Caution
• Installation and maintenance must be performed by a
qualified electrician in accordance with local, state, and
national electrical codes (NEC) and requirements.
Spring
arms
To
lamps
Push the spring
arms together
and insert the
sensor
Locknut
Figure 5: Wiring Connection
Figure 4: Fixture Mount Sensor