Use Instructions

4746
LB-0009ODF-007-00018-DES REV_03
Technical Specications
Mobile Device Compatibility
Android Running 8.0 and up
Apple iPhone running iOS 11.0 and up
Phone hardware must support BLE 4.2 Communication protocol
FCC Declaration
This device complies with Part 15 rules. Operation is subject to the
following two conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received, including interference
that may cause undesired operation
T
hi
s
equipment has been tested and found to comply with the limits of a
C
lass B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference
when the equipment is operated in a residential environment. This equipment
generates, uses, and radiates radio frequency energy, and if not installed
and used in accordance with the instructions, may cause harmful
interference. However, there is no guarantee that interference will not occur.
If this equipment does cause interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
To which this declaration relates, is in conformity with the following standard:
• EMC FCC Part 15 (B) Class B
• Radio 47 CFR Part 15.247 Contains FCC ID: HSW2832 for wareable
sensor
• Radio 47 CFR Part 15 FCC ID: 2AY5U-A for wireless charger
FCC Caution
Changes or modications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
RF Exposure
The wireless charger unit complies with FCC radiation exposure limits set forth
for an uncontrolled environment and meets the FCC radio frequency (RF)
Exposure Guidelines. This wireless charger should be installed and operated
keeping it at least 20cm or more away from person’s body.
Guidance and Manufacturer’s Declaration –
Electromagnetic Emissions
MotionSense® has been tested and found to comply with the electromagnetic
compatibility (EMC) limits for medical devices IEC 60601-1-2:2014.
RF Emissions CISPR 11 Class B, Group 1
Harmonic Current Emission
IEC 61000-3-2
Applicable, Class A
Voltage change, Voltage
fluctuations and Flicker Emission
IEC 61000-3-3
Conducted Immunity
IEC 61000-4-6
Emissions/Immunity Test Compliance Level
Applicable
Applicable, 3 Vrms, 6 Vrms ISM Bands
and amateur radio Bands
Immunity to Proximity Fields
from RF wireless communication
equipment
IEC 61000-4-3
80 MHz to 2.7 GHz, 10 V/m
Electrostatic discharge (ESD)
IEC 61000-4-2
±8 kV Contact, ±15 kV Air