USER MANUAL V0.9 Pushbutton Transmitter Device PTM 210 / 210C October 18, 2011 Patent protected: US 6,747,573 US 7,019,241 Further patents pending EnOcean GmbH Kolpingring 18a 82041 Oberhaching Germany Phone +49.89.67 34 689-0 Fax +49.89.67 34 689-50 info@enocean.com www.enocean.com Subject to modifications PTM 210 / 210C step EA User Manual V0.
USER MANUAL V0.9 PTM 210 / 210C STEP EA REVISION HISTORY The following major modifications and improvements have been made to the first version of this document: No 0.95 Major Changes New EEP naming included (EEP 2.1) Published by EnOcean GmbH, Kolpingring 18a, 82041 Oberhaching, Germany www.enocean.com, info@enocean.com, phone ++49 (89) 6734 6890 © EnOcean GmbH All Rights Reserved Important! This information describes the type of component and shall not be considered as assured characteristics.
USER MANUAL V0.9 PTM 210 / 210C STEP EA TABLE OF CONTENT 1 1.1 1.2 1.3 1.4 1.5 1.6 2 2.1 2.2 2.3 3 3.1 3.2 3.3 3.4 4 4.1 4.2 4.3 GENERAL DESCRIPTION .................................................................................... 4 Basic Functionality ........................................................................................... 4 Typical Applications .......................................................................................... 5 Technical Data .............................
USER MANUAL V0.9 PTM 210 / 210C STEP EA 1 GENERAL DESCRIPTION The radio transmitter device PTM 210 / PTM 210C from EnOcean enables the implementation of wireless remote controls without batteries. Power is provided by a built-in electrodynamic power generator. The PTM 210 / PTM 210C device serves the 868 MHz / 315 MHz air interface protocol of EnOcean.
USER MANUAL V0.9 PTM 210 / 210C STEP EA 1.2 Typical Applications Building installation Industrial automation Consumer electronics Key applications are wall-mounted flat rocker switches with 1 or 2 rockers, as well as handheld remote controls with up to 4 single pushbuttons. Because the RF transmitters are selfpowered (no batteries), maintenance-free RF systems are possible. 1.
USER MANUAL V0.9 PTM 210 / 210C STEP EA Energy Bow Stopper PTM 210 without antenna, tilted view (including rocker catwalks) 1) this catwalks are not needed when using one single rocker only 2) dimensions of rocker part PTM 210 without antenna, top view (note cut A, B and C marking) EnOcean GmbH Kolpingring 18a 82041 Oberhaching Germany Phone +49.89.67 34 689-0 Fax +49.89.67 34 689-50 info@enocean.com www.enocean.com Subject to modifications PTM 210 / 210C step EA User Manual V0.
USER MANUAL V0.9 PTM 210 / 210C STEP EA PTM 210 without antenna, cut A 2) dimensions of rocker part PTM 210 without antenna, cut B and C EnOcean GmbH Kolpingring 18a 82041 Oberhaching Germany Phone +49.89.67 34 689-0 Fax +49.89.67 34 689-50 info@enocean.com www.enocean.com Subject to modifications PTM 210 / 210C step EA User Manual V0.
USER MANUAL V0.9 PTM 210 / 210C STEP EA antenna labeling area Hatched areas: support planes PTM 210C with antenna (PTM 210 provides internal antenna), rear view EnOcean GmbH Kolpingring 18a 82041 Oberhaching Germany Phone +49.89.67 34 689-0 Fax +49.89.67 34 689-50 info@enocean.com www.enocean.com Subject to modifications PTM 210 / 210C step EA User Manual V0.
USER MANUAL V0.9 PTM 210 / 210C STEP EA catwalks of switch rocker rotary rocker tilted to 5.4 degrees (corresponds to 1.8 mm energy bow travel) support plane mounting plane press bow to stopper 2) dimensions of rocker part PTM 210 without antenna, side view If the rocker is not mounted on the rotation axis of PTM 210 several tolerances have to be considered! The measure from support plane to top of the energy bow is 7.70 mm +/- 0.
USER MANUAL V0.9 PTM 210 / 210C STEP EA 1.5 Environmental Conditions Operating temperature -25 °C up to +65 °C Storage temperature -25 °C up to +65 °C Humidity 1.6 0% to 95% r.h. Ordering Information Type PTM 210 PTM 210C Ordering Code S3001-A210 S3031-A211 2 FUNCTIONAL DESCRIPTION 2.
USER MANUAL V0.9 PTM 210 / 210C STEP EA Processor Converts the contact nipples’ status and pushed/released data from the power generator into a reliable and energy-efficient serial telegram structure. HF transmitter Sends the data in the form of a series of short radio signals. 2.2 Contact Nipples Designation With 4 contact nipples, the PTM 210 offers 2 channels with 4 action states each (upper/lower nipple is pressed/released when activating the energy bow).
USER MANUAL V0.9 PTM 210 / 210C STEP EA 2.3 Transmission timing The transmission timing of the radio device PTM 210C has been developed to avoid possible collisions with data packages of other EnOcean transmitters as well as disturbances from the environment. With each transmission cycle, at least three identical subtelegrams are transmitted. The transmission of a subtelegram lasts approximately 0.7 ms.
USER MANUAL V0.9 PTM 210 / 210C STEP EA 3 APPLICATIONS INFORMATION 3.1 Laying the antenna (PTM 210C only) > 25mm For best performance the antenna cable should be layed as shown in the figure below.
USER MANUAL V0.9 PTM 210 / 210C STEP EA Example of a well suited antenna 3.2 Construction of application specific Switch Rockers For CAD system development support, 3D construction data is available from EnOcean (IGS data). Using this data, the mechanical interface is fixed, and the shape and surface of the rocker(s) can be changed according to requirements. Recommendation for suitable rocker material is polycarbonate (buckling resistant and wear-proof material).
USER MANUAL V0.9 PTM 210 / 210C STEP EA 3.4 Transmission Range The main factors that influence the system transmission range are type and location of the antennas of the receiver and the transmitter, type of terrain and degree of obstruction of the link path, sources of interference affecting the receiver, and “dead” spots caused by signal reflections from nearby conductive objects.
USER MANUAL V0.9 PTM 210 / 210C STEP EA 4 AGENCY APPROVALS 4.1 CE Approval (PTM 210 only) The devices bear the EC conformity marking CE and conform to the R&TTE EU-directive on radio equipment. The assembly conforms to the European and national requirements of electromagnetic compatibility. The conformity has been proven and the corresponding documentation has been deposited at EnOcean.
USER MANUAL V0.9 PTM 210 / 210C STEP EA Changes or modifications made to this equipment not expressly approved by EnOcean may void the FCC authorization to operate this equipment. 4.3 Japanese Type Approval (PTM 210C only) PTM 210C complies with the Japanese radio law. It carries the following marking on the back side label (MIC marking): +++ in preparation +++ If the certification label cannot be recognized from outside (e.g.
