User's Manual

USER MANUAL

PTM 210 / PTM 215 / PTM 215U / PTM 215J

DC Step code and later

5.3.4.2 NEW NFC PIN

The NFC PIN used to protect access to the CONFIGURATION memory area should be changed

from the default value to a user-specific value to avoid unauthorized access to the NFC device

configuration interface.

To do so, first authenticate with the current NFC PIN and then write the new NFC PIN (32-bit

value) to memory.

The new NFC PIN will be applied to the PTM module after pressing & releasing the energy

bow. Until then, the previous NFC PIN will remain valid to unlock the NFC memory.

5.3.4.3 SECURITY LEVEL

The security level register defines what encryption features are used in the radio transmis-

sion. If this register is changed from its default setting via the NFC interface, manual mode

changes via SBC (as described in chapter 3.3) are no longer possible. Both 2 nipple SBC and

3 nipple SBC will still trigger the transmission of a Security Teach-in but in both cases the

mode selected via NFC (If secure mode was selected)

To re-enable the “mode change by SBC”, a factory reset needs to be executed. The mode

change via NFC remains possible even after first write operation.

The operation and application behaviour of the selected mode is described in chapter 3. Fol-

lowing options can be selected:

 0b00000000: Normal mode operation

 0b00000001: Secure mode – Implicit RLC legacy

 0b00000010: Secure mode – Explicit RLC (recommended)

 0b00000011: Defined by SBC (default). This value cannot be set by NFC write

operation.

0b0000 0100 – 0b1111 1111: RFU

5.3.4.4 ALLOW TEACH IN

This flag controls if a Security Teach-in can be triggered by SBC. The Security Teach-in Tel-

egram is described in chapter 3.2.3. The following values can be set:

 0b00000000: OFF: SBC will not trigger a secure teach-in telegram

 0b00000001: ON (default): SBC will trigger a secure teach-in telegram.

0b0000 0010 – 0b1111 1111: RFU