User's Manual

USER MANUAL PREVIEW
PTM 535BZ – BLUETOOTH AND ZIGBEE GREEN POWER PUSHBUTTON TRANSMITTER
© 2022 EnOcean | www.enocean.com F-710-017, V1.0 PTM 535BZ User Manual | v1.2 | July 2021 | Page 37/121
4.4.2.1 Application Information
PTM 535BZ provides Application Information according to the ZGP specification [3] as part
of the commissioning telegram to describe the command set used by it.
It is possible to disable the transmission of the Application Information field for Device ID
other than 0x07 via NFC to maintain backwards compatibility to older ZGP implementations.
In this case, none of the fields listed below is present.
Application Information depends on the Device ID and consists of the following fields:
 Type (1 byte)
The Type field identifies the type of the application information that follows
 Length (1 byte)
The Length field indicates the size (number of bytes) of application information data
that follows.
 Data (variable)
The Data field contains either the application information data
Figure 29 below shows the structure of the Application Information field.
Figure 29 – Application Information structure
4.4.2.2 Application Information for Device ID 0x07
The Application Information structure for Device ID 0x07 contains the Switch Information
field information about the switch type (Generic Switch Configuration) and the input status
that triggered the commissioning event (Current Contact).
Figure 30 below illustrates the Application Information structure for Device ID 0x07.
Figure 30 – Application Information structure for Device ID 0x07