User's Manual

USER MANUA

V0.82

TCM 300 / 300C / 320 / 320C

RD _ BASEI D

Bit 7 Bit 0

When this command is sent to the TCM, the base ID range num-

ber is retrieved though an INF_BASEID telegram.

I NF_ BASEI D

Bit 7 Bit 0

This message informs the user about the ID range base number.

BaseIDByte3 is the most significant byte.

SET_ RX_ SENSI TI VI TY

Bit 7 Bit 0

This command is used to set the TCM radio sensitivity.

In LOW radio sensitivity, signals from remote transmitters are

not detected by the TCM receiver. This feature is useful when

only information from transmitters in the vicinity should be proc-

essed. An OK confirmation telegram is generated after TCM sen-

sitivity has been changed.

Sensitivity=0x00 Low sensitivity

Sensitivity=0x01 High sensitivity

0 xA5

0 x5 A

0 xAB

0 x5 8

Chk Su m

0 xA5

0 x5 A

0 x8 B

0 x9 8

BaseI D Byt e3

BaseI D Byt e2

BaseI D Byt e1

BaseI D Byt e0

Chk Su m

0 xA5

0 x5 A

0 xAB

0 x0 8

Sensit ivit y

Chk Su m