User's Manual
Table Of Contents
- 1 GENERAL DESCRIPTION
- 2 FUNCTIONAL DESCRIPTION
- 2.1 Simplified firmware flow chart and block diagram
- 2.2 Pin out
- 2.3 Pin description and operational characteristics
- 2.4 Absolute maximum ratings (non operating)
- 2.5 Maximum ratings (operating)
- 2.6 Power management and voltage regulators
- 2.7 Configuration
- 2.8 Radio telegram
- 2.9 Transmit timing
- 2.10 Charging circuitry
- 2.11 Energy consumption
- 3 APPLICATIONS INFORMATION
- 4 AGENCY CERTIFICATIONS
USER MANUA
L
V0.6
© 2010 EnOcean | www.enocean.com STM 31x / STM 31xC User Manual V0.6 | Page 27
/
28
STM 31X / STM 31XC
OEM Requirements
In order to use EnOcean’s FCC ID number, the OEM must ensure that the following condi-
tions are met.
End users of products, which contain the module, must not have the ability to alter the
firmware that governs the operation of the module. The agency grant is valid only when
the module is incorporated into a final product by OEM integrators.
The end-user must not be provided with instructions to remove, adjust or install the
module.
The Original Equipment Manufacturer (OEM) must ensure that FCC labeling requirements
are met. This includes a clearly visible label on the outside of the final product. Attaching
a label to a removable portion of the final product, such as a battery cover, is not per-
mitted. The label must include the following text:
STM 310C, STM 312C:
Contains FCC ID: SZV-STM310C
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (i.) this device may not cause harmful interference and
(ii.) this device must accept any interference received, including interference that
may cause undesired operation.
STM 311C:
Contains FCC ID: SZV-STM311C
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (i.) this device may not cause harmful interference and
(ii.) this device must accept any interference received, including interference that
may cause undesired operation.
When the device is so small or for such use that it is not practicable to place the state-
ment above on it, the information required by this paragraph shall be placed in a promi-
nent location in the instruction manual or pamphlet supplied to the user or, alterna-
tively, shall be placed on the container in which the device is marketed. However, the
FCC identifier or the unique identifier, as appropriate, must be displayed on the device.
The user manual for the end product must also contain the text given above.
Changes or modifications not expressly approved by EnOcean could void the user's au-
thority to operate the equipment.
The OEM must ensure that timing requirements according to 47 CFR 15.231(a-c) are
met.
The OEM must sign the OEM Limited Modular Approval Agreement with EnOcean
The module must be used with only the following approved antenna(s).