User manual

9
MANUAL • Mounting
REF: OSHPD# OPA=2671-10
STEP 1
Determine Your desired keyboard height. Use the chart on previous page for
standard keyboard heights, adjust vertical dimensions as required for desired
keyboard height.
STEP 2
Locate the exact center line of the wall stud where the arm will be mounted.
STEP 3
Using a level, mark the hole locations for the appropriate track size using the
dimensions to the left (make note of the bottom of the track).
STEP 4
Place the track against the wall and secure with the Wide Flat Washer, the
Phenolic Washer and the Hex Nut Self Tapping Metal Screw
DO NOT DRILL PILOT HOLES.
STEP 5
Ensure track is level before fully tightening screws.
DO NOT OVER TIGHTEN SCREWS . If hole strips out see page 10.
1/4-14 x 2 1/2”
Hex Nut Self Tapping Metal Screw
Phenolic Washer
Wide Flat Washer
Preferred Method of Mounting
20 Gage (.035") or Heavier Metal Stud