User manual

10
MANUAL • Mounting
STEP 4
Drill a 3/16" pilot hole into each of the mounting hole locations. Use the Wide
Flat Washer, Phenolic Washer and the Hex Nut Wood Screw to secure the track
to the wall.
STEP 5
Ensure track is level before fully tightening screws.
Follow Steps 1 through 3 from the previous page
(Hardware not included)
Follow Steps 1 through 3 from the previous page
STEP 4
Drill a ½" holes through the center of the striped hole and install
SNAPTOGGLE
®
brand hollow wall anchors. (See wall anchor installation
instructions on page 11)
STEP 5
Ensure track is level before fully tightening with cross drive 1/4"-20 x 2 1/2" screws.
Wood Stud Mounting (Hardware not included)
1/4-14 x 4”
Hex Nut Wood Screw
Phenolic Washer
Wide Flat Washer
Wall
Wall Anchor
Track
Track
Metal Stud
METAL STUD HOLLOW WALL
Wall
For Striped Holes or
Lighter than 20 (.035") Gage Metal Studs