Enphase Encharge Battery System Quick Install Guide

Mount the Encharge Battery(ies) on the wall
* WARNING: Risk of injury. Take care when lifting.
Each Encharge Battery is heavy (47 kg/ 104 lbs) and requires two
persons to lift.
* WARNING! Risk of injury and equipment damage. Avoid dropping
the Encharge Battery(ies). Doing so may create a hazard, cause seri-
ous injury, and/or damage the equipment.
* WARNING! Risk of injury and equipment damage. Protect the
Encharge Battery(ies) from impact damage and improper use.
A ) Take the Encharge battery unit from the packaging and place it right
side up on a at surface.
B ) Begin by installing the Encharge battery unit located closest to the
main supply. Supporting the Encharge battery unit from underneath
the unit, lift the Encharge battery unit, hold it at an angle so the top of
the Encharge battery unit sets into the top of the wall-mount bracket.
C ) Once the top of the battery is engaged with the top tabs of the wall-
mount bracket, keep the battery vertical, make sure the battery is ush
against the bracket, and lower the battery down until fully seated on
the wall-mount bracket shelf.
D ) Attach the battery to the mounting bracket aligning the screw hole at
the top of the battery with the screw hole at the top of the bracket.
* WARNING! Risk of injury and equipment damage. Do not release
the Encharge battery unit until you ensure that the Encharge battery
unit is fully seated in the wall-mount bracket shelf.
5
Top screw hole
DC Switch
Scannable/removable
serial number label