storage system owner's guide
4
Read this rst
This manual describes the safe use Enphase storage with Ensemble™
energy management technology.
Do not remove the dead fronts (plastic guards inside enclosure) from
the Enpower and Combiner.
Do not open the Encharge battery unit unless to use the DC switch
Safety and advisory symbols
To reduce the risk of electric shock, and to ensure the safe installation
and operation of the Enphase storage system, the following safety
symbols appear throughout this document to indicate dangerous
conditions and important safety instructions.
DANGER
This indicates a hazardous situation, which if not avoided, will
result in death or serious injury. Use extreme caution and follow
instructions carefully.
WARNING
This indicates a situation where failure to follow instructions may
be a safety hazard or cause equipment malfunction. Use extreme
caution and follow instructions carefully.
NOTE
This indicates information important for optimal system
operation. Follow instructions carefully.
Safety Instructions
A battery can present a risk of electrical shock, re, or
explosion from vented gases. Only qualied electricians should
install, troubleshoot, or replace the Enphase storage equipment
or wiring.
If the Enphase storage equipment generates smoke, remove
AC power from the Enphase system, and turn the DC switch
on Encharge battery(ies) to the OFF position, following the
instructions in the manual.
In case of re, use a standard or carbon dioxide re extinguisher
or another appropriate extinguisher to put out the re.
Do not dispose of Encharge battery(ies) in a re or by burning.
Do not allow or place ammable, sparking, or explosive items
near the Enphase storage system equipment.
During use, when stored, or during transport, keep the Encharge
battery in an area that is well ventilated, where the ambient
temperature is between -15º C to 55º C (5º F to 131º F).
Risk of electric shock. In areas where ooding is possible, install
the Enphase storage system equipment at a height that prevents
water ingress.
Read this entire document before using Enphase storage
systems.
Do not attempt to repair the Enphase storage equipment; it
contains no user-serviceable parts. Do not open the Encharge
battery unit under the Encharge cover. Doing so will void the
warranty. If the Enphase storage equipment fails, contact your
solar installation professional or Enphase at enphase.com/en-us/
support/contact.
The Encharge battery is designed for stationary installation only.
It is not designed for mobile applications such as installation on
vehicles and trailers and should not be used in such applications.
Risk of equipment damage. During use, storage, transport, or
installation, always keep the Enphase storage equipment in an
upright (top side up) position.
Important Safety Information