Install Manual
Table Of Contents
- SAFETY
- The Enphase Envoy-S
- Installation Planning and Preparation
- Installing the Envoy-S
- Activate Monitoring
- Envoy-S Operation
- Connecting to Envoy-S
- Troubleshooting
- Technical Data
Envoy-S Installation and Operation
2015 Enphase Energy Inc. 141-00027 Rev 01
22
Activate Monitoring
Register the Envoy-S for monitoring of the Enphase Microinverters in Enlighten at
enlighten.enphaseenergy.com. Once you have registered the system and successfully installed the Envoy-S,
Enlighten sets up an account for the site owner. When you complete the registration and installation,
Enphase sends account information to the site owner so that they can log in to the Enlighten website and
view system performance.
Method A: If the Envoy-S is Associated with a System in Installer Toolkit
a. On your mobile device, go to your Wi-Fi settings and disconnect from the Envoy’s AP network. (This
should restore Internet connectivity to your device).
b. Return to the Installer Toolkit app and tap the Sync button on the System Overview screen.
c. Log in to Enlighten and click on the system activation’s name from the installer dashboard.
d. From the activation form, open Array Builder.
To see the Array Builder demo, go to
enphase.com/support/videos.
If you used Installer Toolkit to build arrays
and scan microinverter serial numbers,
the array(s) are built. Make any necessary
adjustments in Array Builder.
If you did NOT use Installer Toolkit to
build arrays and scan microinverter serial
numbers, create the virtual array in Array
Builder using the installation map as your
reference. (You may need to wait if the
microinverters have not yet reported to
Enlighten.)
Method B: If the Envoy-S is NOT
associated with a System in Installer Toolkit
a. Log into Enlighten and click Add a New System from the installer dashboard.
b. Enter the System, Installer, Owner, and Location information.
c. Enter the Envoy serial number.
d. Click Save to submit the form.
e. After the microinverters have reported to Enlighten, open Array Builder from the activation form, and
create the virtual array, using the installation map as your reference. To see the Array Builder demo,
go to enphase.com/support/videos.
View System Performance in
Enlighten
Once the array is built and the system is
activated, you can log in to Enlighten to view site
data. Enlighten displays a graphic
representation of the PV system. It also shows
detailed current and historical performance
information.