IQ Disconnect Tool Manual

IQ 6/IQ 6+ Micro Installation and Operation

Step 7: Terminate the Unused End of the Cable

Terminate the unused end of the Enphase Q Cable as follows.

A. Remove 13 mm (½ inch) of the cable sheath from the conductors. Use the terminator loop to

measure 13 mm.

B. Slide the hex nut onto the cable. There is a grommet inside of the hex nut that should remain

in place.

C. Insert the cable into the terminator body so that each of the two wires land on opposite sides

of the internal separator.

Internal View

Terminator

Body

13mm