Foreword Contents 1. Contents / Attentions..............................................................................1 2. Foreword / System Introduction / System Feature/ System Type.................2 3. WR400&4Front and rear panel function instruction....................................3 4. HT400 / PT400 Transmitter function instruction........................................4 5. HT400 / PT400 Transmitter battery installation.........................................5 6.
WR400& 4 Front& rear panel function/ instruction (1) ( 6 )(7) (6)(7) ( 6 )( 7 ) ( 6 )( 7 ) HT400 Transmitter Function/Instruction (3) ( 2 ) (1) (4)(8)( 5 ) (4)(8)( 5 ) (4)(8)( 5 ) AA (4)(8)( 5 ) L M H AA (6) Front Panel (3) (2) (10 )( 1 1 )(12) (1 2 ) (13)(14) ( 1 2 ) (12) (9) (4) ON Rear Panel 1. Front Antenna Hole A: Move the receiving antenna to front panel. 2. Front Antenna Hole B: Move the receiving antenna to front panel. 3. Power Switch: Power ON/OFF the receiver. 4.
Transmitter Battery Installation 1. Battery Installation of Handheld Microphone: Unlock the battery cover and take it out, insert the supplied batteries into battery jar in polarity and cover the battery cover, then lock. Three Types of Bodypack Transmitter Connection 1 .
Receiver Installation in 19 Inch Equipment Rack System Connection 1. Receiver Power Connection: Connect the DC connector of supplied AC/DC adapter into the DC power input of receiver. Plug the AC input connecter into an AC120/60Hz or AC220V/50Hz outlet. (Shown as below) Put the receiver into a suitable position of 19 inch equipment rack, tighten with four fixed screw so that the receiver can be installed to the rack easily. 2.