. Antenna. 2. LCD Information Display: Show the transmitter power/frequency channel ect. 3.Up Function Button: Sets channel data. 4. Down Function Button: Sets channel data. 5. Power / Mute Button: Power ON/OFF transmitter. 6. Battery Cover: Open the cover and set Alkaline batteries, or NI-MG rechargeable batteries. 7. Antenna Connector. 8. Input Connector: It is TA4 PINS connector; It is suitable for the lavaliere microphone system/ Headset microphone systems/ Guitarist microphone system.
RECEIVER OPERATION INSTRUCTION (CHANNEL DATA SETTING) 1. Tum on the receiver. Length press Length press 7% Dotcom] [e=% (est ze) of 2. Channel Set Up: Press Up and Down bunion to select the channel data. af Go" Fob (Mummify) of 2.1 Length press "MANY" to enter channel setting mode, the figure is flashing, during three seconds after operation is finished. the system will lock and save the message and then exit. 2.
Resolver Output Connector: High Z Audio Low Z Audioā€¯ Output Configuration: { Overbalance} Actual Impedance: 3kG 8000 * Output Level: Microphone Liveliness Levelheaded Receiver Audio Output Level (25 KHz deviation, 400Hz tone) XLR connector (into 600 ohm load): 24mV 1/4 inch connector {into 3000 ohm load): 360mV Impedance: Body Pack (input): 500kQ (GT) Receiver : 50 tums antenna level; 3000 ohm at mic level Modulation: FM; 1:25KHz RF Power Output: 10 mW Dynamic Range: >100 dB RF Sensitivity: -105dBm (S/N -12