User's Guide

1、Plug the Mini Receiver into the 6.35mm mic input of your audio device.
2、Hold and press the “POWER” button of the Mini Receiver for about 3 seconds to power it
on.
3、Hold and press the “POWER” button of the Transmitter for about 3 seconds to power it on.
4、When you see the “RF” indicator in the Mini Receiver lights up, the wireless microphone
system is ready to be used.
**If you would like to use multiple sets together, pair the system manually
following the steps below:
Step1:Power off the Transmitter and receiver.Press the “-” button in the Transmitter, then
hold and press the POWER button in the Transmitter until you see ---- displays in the
LCD screen.
Step2:Power on the Mini Receiver. When you see the RF indicator lights up, the Transmitter
is paired with the receiver.
Step3:Hold and press the “+” or “-” button in the Transmitter for about 3 seconds until you
see “CHXX” displays in the LCD screen, short press “+” or “-” button to select the
most appropriate frequency point. Make sure every set is working at different
frequency points.
Step4:The Transmitter will exit frequency selection in about 5 seconds. You will be able to
short press the “+” or “-” button to change the microphone volume.
1
Product Illustration
Please read through this user guide and make yourself familiar
with the operations below before you use the product.
3、Charging status light: it is solid red during charging and will turn solid green when it is
fully charged.
4、Signal indicator: When only CHA is connected, it is solid blue; when only CHB is
connected, it is solid red. When both CHA and CHB are connected, it is purple.
5、Battery level indicator: This indicator will be solid green when there is sufficient power.
It turns red when battery is low and please charge it in time.
Mini Receiver
1、6.3mm plug
2、Antenna
UHF WIRELESS MICROPHONE SYSTEM
USER MANUAL
UHF WIRELES S MICROPHONE SYS TEM
1
7
5
4
2
3
6