User Manual

SUGGESTED MOUNTING POSITIONS:
The EC1865BM can be mounted in three different configurations. Always
double check for mounting depth limitations, never cut before you check.
PRIOR TO INSTALLING THIS PRODUCT:
Inspect your speaker before beginning installation. Notify your Enrock dealer if you
notice any damaged parts. Hold on to the box as well as packaging material in case it
needs to be transported.
Speaker damage can occur when an amplifier is made to play at higher listening
levels than it can produce at low distortion levels. A speaker will get damaged when
trying to get too much volume from a low-powered amplifier or receiver than from a
high powered one.
To avoid potential shorts in the electrical system, be sure to disconnect the (-) battery
cable before installation. Use this unit with a 12-volt battery and negative grounding
only.
When replacing a fuse, be sure to only use a fuse of the rating specified on this
product.
To avoid short-circuiting, cover any disconnected leads with insulating tape. It is
especially important to insulate any unused wires, which if left
uncovered may cause a short circuit. When connecting other devices to this product,
refer to the manual for the product to be connected. The black cable is ground, make
sure to connect the ground wire first.
Ensure that the ground cable is properly connected to metal parts of the vehicles
body frame or direct to the battery, if your vehicle does not have a grounded chassis
frame. The ground cable of this unit’s power amp and a second powered system
must be connected to the frame separately with different screws. If the screw for the
ground wire loosens or falls out, it could result in fire or malfunction
EC1865BM
GROUND CABLE
METAL FRAME
YOUR AMPLIFIER
SPEAKER 1
SPEAKER 2
+
-
+
-
+12V BATTERY YELLOW
REMOTE OUT
+12V BLUE
CHASSIS
GROUND
POINT
BATTERY
OPTIONAL DIRECT BATTERY WIRING CIRCUIT
BLACK
OPTIONAL
FUSE AND FUSE HOLDER
(NOT INCLUDED)
CHASSIS
GROUND
POINT
Normally Open
ON/OFF ACC switch
YOUR
BATTERY
KILL SWITCH
YOUR RADIO
STRIPPED WIRE NEGATIVE
12FT