User Manual

Device Management

DVR User Manual

11.1.9 Platform Access

Some models may not support this function.

This function is mainly used for connecting ECMS/NVMS. The setting steps are as follows.

Click StartSettingsNetworkPlatform Access to go to the interface.

Platform Access

① Set “Access Type” as “Platform Software” and select “Enable” as shown below.

② Check the IP address and port of the transfer media server in the ECMS/NVMS. The

default server port for auto report is 2009. If it is modified, please go to the transfer media

interface to check.

③ Enable the auto report in the ECMS when adding a new device. Then self-define device

ID and input the remaining information of the device in the ECMS/NVMS.

④ Input the above-mentioned server address, port and report ID in the server interface. Then

click the “Apply” button to save the settings. Now the ECMS/NVMS system will

automatically connect this device.

11.1.10 SNMP

① Click StartSettingsNetworkSNMP to go to the interface for SNMP configuration.