User Manual

Live Preview Introduction
DVR User Manual
33
5.3 POS Settings
Some models may not support this function.
① Click StartSettingsBasicPOS Settings to go to the interface.
② Enable POS and click configure under “Connection Settings” to go to the following
interface.
③ Input IP address of the POS you want to add.
④ Check “Filter destination”, “Filter POS port” and “Filter destination Port” (If you do not
check them, please skip this step) and input destination IP, POS port and destination port you
want to filter.
⑤ Click “Display Position” under “Display Settings” to set the position of the POS
information (Use the default settings of the general settings).