User Manual

User’s Manual
270
Parameter Description
Port Mapping
Enable the UPnP function.
After it is enabled, the intranet services and ports shall be mapped to
extranet, proceed with caution.
Status
Indicates the status of UPnP function.
Offline: Failed.
Online: Succeeded.
LAN IP
Enter IP address of router on the LAN.
After mapping succeeded, the system obtains IP address automatically
without performing any configurations.
WAN IP
Enter IP address of router on the WAN.
After mapping succeeded, the system obtains IP address automatically
without performing any configurations.
Port Mapping List
The settings in PAT table correspond to the UPnP PAT table on the router.
Service Name: Name of network server.
Protocol: Type of protocol.
Int. Port: Internal port that is mapped on the Device.
Ext. Port: External port that is mapped on the router.
 To avoid the conflict, when setting the external port, try to use the
ports from 1024 through 5000 and avoid popular ports from 1
through 255 and system ports from 256 through 1023.
 When there are several devices in the LAN, reasonably arrange the
ports mapping to avoid mapping to the same external port.
 When establishing a mapping relationship, ensure the mapping
ports are not occupied or limited.
 The internal and external ports of TCP and UDP must be the same
and cannot be modified.
 Click to modify the external port.
Click Apply to complete the settings.
In the browser, enter http://WAN IP: External IP port. You can visit the LAN Device.
5.15.1.9 Configuring SNMP Settings
Not all models support this function.
You can connect the Device with some software such as MIB Builder and MG-SOFT MIB Browser to
manage and control the Device from the software.