User's Manual

Ensemble Communications Inc.
CPE Site Setup 6-5
Figure 6-1. CPE Pole Mount Assembly
6. Attach the antenna to the mounting plate, orienting it for
proper polarization (see the next sections) and LOS alignment
with the base stations.
7. After aligning the antenna, tighten the mounting clamps.
Lightning Suppressor
Installation
Note A lightning suppressor is not shipped with the ODU. See page 3-10 for
the Ensemble-recommended lightning suppressor.
WARNING
It is not possible to guarantee that lightning protection will
be 100 percent effective against a direct lightning strike.
Install one suppressor as close as possible to the point at which the
cable enters the building. Another suppressor should be installed
as close as possible to the ODU. See Table 6-2 and Table 6-3 for
illustrations of the suppressor installation.
Elevation (6)
Markers
Alignment (5)
Bracket
Azimuth (7)
Alignment
Bolt
Vertical Alignment Bolt
(2)
(1) Mast
Flat Washer
Lock Washer
Nut
(3) Mounting
Clamps
(4) Mounting
Rack