Programming instructions

Section 6 — Effect Parameters
Edit/Effects Parameters 9
DISTORTION MIX Range: 0 to 99
Determines the Dry/Wet, or in this case, dirty/clean mix of the signal. A value of 0 yields a clean
signal; 99 yields an all distortion signal.
REVERB DECAY TIME HI FREQ BANDWIDTH
LOW FREQ DECAY REVERB DETUNE RATE/AMT
HI FREQ DAMPING
See the descriptions under HALL REVERB.
EARLY RFLECTION LEV CHORUS MIX
CHORUS RATE/AMT
See the descriptions under CHORUS+REVERB.
ROM-13 WAH+DIST+REV
A guitar and amp simulator, featuring distortion, compression, reverb, and a resonant filter
following the amplitude of the signal. Assign a sound to BUS1 for Wah distortion and reverb;
use BUS2 for reverb only. BUS3 is dry.
BUS1 REV AFTER DIST Range: 0 to 99
This parameter controls the Dry/Wet mix of the Distortion.
BUS2 REVERB MIX REVERB DAMPING
REVERB DECAY TIME
See the descriptions under HALL REVERB.
COMPRESSOR THRESHLD DIST GAIN IN and OUT
See the descriptions under CMP+DIST+REV.
WAH FILTER CENTER Range: 0 to 99
Determines where the resonant peak of the wah will occur. Higher values create a higher pitched
wah.
WAH RANGE Range: -99 to +99
Controls how much depth the wah will have. This is analogous to how far you move a wah-wah
pedal back and forth.
SYSTEM FEEDBACK
See the descriptions under CMP+DIST+REV.