Programming instructions

Section 6 — Effect Parameters ASR-10 Musician’s Manual
26 Edit/Effect Parameters
This parameter controls the time delay for the right channel regen delay. This is the “pong.”
DELAY FEEDBACK Range: -99 to +99
This parameter controls the level of the delay time taps. The sign of the value determines the
polarity of the feedback.
ECHO TIME L Range: 0 to 1500 ms
This parameter controls the flanger echo time for the left side. Higher values yield a deeper echo.
ECHO TIME R Range: 0 to 1500 ms
This parameter controls the flanger echo time for the right side.
ECHO LEVEL Range: 0 to 99
This parameter controls the volume of the discrete echoes for both the left and right sides. A
setting of 0 would eliminate any audible echo.
BASS FC Range: 0 to 1000 Hz
This parameter sets the cutoff frequency of the lower frequency band shelving filter.
GAIN Range: -48 to +24 dB
This parameter sets the amount of boost or cut applied to the low shelving filter.
TREBLE FC Range: 1KHz to 15KHz
This parameter selects the cutoff of the upper frequency band high shelving filter.
GAIN Range: -48 to +24 dB
This parameter sets the amount of boost or cut applied to the high shelving filter.
EQ TRIM Range: -24 to +0 dB
This parameter allows you to adjust the input volume of the EQs to eliminate the possibility of
clipping boosted signals.
MOD SRC 1 MOD SRC 2
DST 1 DST 2
MIN 1 MIN 2
MAX 1 MAX 2
These parameters are explained in detail in Section 5 — Effect Concepts.