Programming instructions

Section 1 — Controls and Architecture ASR-10 Musician’s Manual
8 Front Panel Controls
Additional Front Panel Controls
11
87
9
8 7 6 5 4 32 1
A B
FX Select
FX Bypass
Sample
Source Select
Play
Continue
StopRecord
Signal
Peak
Left Right
Input Level
5
10
6
Audio Tracks
Instruments
Sequence Tracks
5) Display
The ASR-10 Display is divided into two main sections: the Indicator Lights in the top half of the
window and the 22-character Alphanumeric Display at the bottom of the window.
FILE 2 GRAND PIANO
LOAD INST STOP
Sequencer
Status
Mode Indicator Page Indicator
22-character Alphanumeric Display
The indicator lights will tell you which mode the ASR-10 is in (Load, Command, or Edit); which
page it is on; and the sequencer status (Stop, Play, Record, etc.). The 22-character alphanumeric
display is used to show you information about specific files, commands, parameters, etc. It will
also ask you for additional input when necessary, such as which track you want to load an
instrument into, or which WaveSample you want to edit.
6) Input Level LED Meters
These 2 dedicated Input Level meters provide separate Left/Right metering of the Audio Input
levels, pre-FX, at all times. The green Signal LEDs light at -24 dB. The red Peak LEDs light at 6
dB below clipping.
7) Sample•Source Select Button
This button is used to initiate sampling (digitally recording sounds) by the ASR-10. The Record
Source selected on this page will determine the audio signal that will be monitored on the Audio
Tracks.