Programming instructions

Section 14 — Storage
Loading and Saving Effects 13
A Note About Saving and Loading from a SCSI Storage Device
The preceding discussion has dealt with saving and loading ASR-10 files using the built-in 3.5
inch floppy disk drive. You can also use a SCSI storage device (through the optional SP-3 SCSI
kit) to store instruments, banks, and sequence files. Much of the saving and loading procedure is
similar to using the floppy disk drive. However, if you are using a SCSI storage device, please
refer to the manual that came with the storage device, and the manual that came with the SP-3
SCSI kit for complete details.
Deleting a File from Disk
Deleting of disk files is done from Load mode. To delete (erase) a file from a disk:
• Press Load, followed by the page button (Instrument, Seq•Song, System•MIDI, or Effects)
for the type of file you want to delete.
• Press the Up or Down Arrow button until the file you want to delete is showing on the
display.
• While holding down the Load button, press Cancel•No. The display will ask DELETE <FILE
NAME>?
• Press Enter•Yes. Press Cancel•No to abort this procedure.