Programming instructions

Appendix
Additional 44 kHz Effect Descriptions I
44 kHz Effect Descriptions and Variations
Version 2 Operating System contains 12 additional 44 kHz effect algorithms specially designed for the
ASR-10. This section will:
• provide the name of each effect as it appears on the display (shown inside the black header),
• list the available preprogrammed variations (shown immediately below the effect name),
• describe the effect,
• show the signal routing diagram (if applicable), and
• list the names of parameters that you can adjust.
At the end of the section is an alphabetized list of all the parameters and what they do.
44LUSH PLATE
1 LUSH REVERB 2 STANDARD REVERB 3 MEDIUM REVERB 4 LONG REVERB
44LUSH PLAT2
1 LUSH REVERB 2 STANDARD REVERB 3 MEDIUM REVERB 4 LONG REVERB
44PERC PLATE
1 AMBIENT REVERB 2 SLAP REVERB 3 SHORT REVERB 4 PERC REVERB
A plate reverb takes the vibrations from a metal plate and uses them to create a metallic-
sounding reverb. 44LUSH PLATE is a 44 kHz small plate reverb offering early reflections;
44LUSH PLAT2 is a larger 44 kHz plate reverb effect; 44PERC PLATE is a 44 kHz plate reverb
optimized for drum and percussion sounds. In general, small plate reverbs are used for drums
and percussion, while large plate reverbs are used to enhance a vocalist’s performance.
LPF
(BW Control)
Predelay
Diffuser
Definition
(Decay Diffuser)
MIX
MIX
Right
Left
L
R
Definition
(Decay Diffuser)
Main
Outputs
Reverb Signal Routing (applies to all plate reverb effects)
DECAY TIME DEPTH
PREDELAY TIME DEFINITION
HF DAMPING DIFFUSION (1 & 2)
BW (bandwidth) ER TIME (L & R)
* not available within 44LUSH PLAT2
DETUNE RATE ER LEVEL (L & R)
* not available within 44LUSH PLAT2
Reverb Parameters (apply to all plate reverb effects, except where noted)