Programming instructions

Section 5 — Effect Concepts ASR-10 Musician’s Manual
10 Selecting Effects
Predefined Effect Modulation Parameters
Several of the effects allow real-time control of a single predefined parameter within the effect,
such as the Reverb Mix or Flanger Feedback. Each of these effects will have its own Modulator
Select screen, where the modulator and mod amount are selected. Each Effect Variation can have
a different assigned Modulation Source and Amount (for a total of four different modulatable
parameters). This screen will look different from effect to effect, but it will always be the last
screen on the Edit/Effect page. The screen has two parameters:
• Mod Source — This selects the source for modulating the defined parameter within the
selected effect.
• Mod Amount (Mix) — This sets the amount the Mod Destination will be modulated by the
Mod Source.
The following modulation sources can alter the effects in performance:
Mod Source Modulation effect derived from
WHEEL the value of the mod wheel
PBEND the value of the pitch wheel (50% output at rest)
PRESS the channel pressure value for the selected track
PEDAL the value of the Pedal/CV input
XCTRL uses the value of the assignable external MIDI controller, set on the
Edit/System•MIDI page
KBD the number of the last key played
VEL average velocity of all keys played simultaneously
KEYDN ON when any keys are held down, otherwise OFF
SUSTN ON when sustain pedal is held down; otherwise OFF
FSW-L uses the left foot switch of the optional SW-10 Foot Switch; ON when
held down, otherwise OFF (Edit/System•MIDI LEFT FOOT SW must
be set to FX MODSRC for this to function as an FX modulator)
PATCH four discrete values, ranging from off (no patch select buttons held) to
full ON (both patch selects held)
OFF no modulation