Use and Care Manual
OPERATION OPERATION
10
LOADING THE BASKET:
STARTING A WASH CYCLE:
1. Draw out the basket(see the secon entled Loading the Dishwasher );
2. Pour in the detergent (see the secon entled Detergent and Rinse Aid );
3. Insert the plug into the socket. The power supply is 120V/60 Hz;
4. Make sure that the water supply is turned on to full pressure;
5. Close the door and press the power buon to turn on the power supply.
6. Press the Program buon to select the wash program you need. NORMAL > LIGHT > MINIPARTY >
RINSE > SPEED > HEAVY
7. Then press the START / RESET buon and the dishwasher will begin to start.
CHANGING THE PROGRAM:
You can modify the washing program if the dishwasher runs for a short me. Otherwise, the detergent
may have already been released, and the appliance may have already drained the wash water. If this is
the case, the detergent dispenser must be relled (see the secon tled “ Loading Detergent “
To change the washing program, more than three seconds the machine will be in stand by state, then
you can change the program to the desired cycle seng. See Starng Wash Cycle secon. The lights
show the state of the dishwasher:
A) All phase lights o: Stand By
B) Display not blinking: Paused
C) Display is blinking: Running
NOTE: If you open the door when washing, the machine will pause. When closing the door, press the
START buon to start the wash cycle back up.
END OF WASH CYCLE:
When the working cycle has nished, the buzzer will sound for 8 seconds, then stop. Turn o the
appliance using the Power buon, shut o the water supply and open the door of the dishwasher.
Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while
they are sll hot and more suscepble to breakage. They will also dry beer. Since the appliance is
standing by, it will power o automacally aer 30 minutes without any operaon
TURNING OFF THE DISHWASHER: All phase lights are o indicang the program has ended.
1. Turn o the dishwasher by pressing the POWER buon.
2. Make sure to turn o the water tap.
NOTE: Take care when opening the dishwasher and handling dishes, they will be hot. Aer a wash has
ended, it is recommended to leave the door open for 30 minutes before unloading.
STARTING THE DISHWASHER: Check to make sure the following steps are followed
1. The dishwasher is level and xed properly.
2. The inlet valve is open
3. There are no leakages at the connecons of the conducts
4. Wires are ghtly connected
5. Power is switched on
6. Inlet and drain hoses are knoed