Use and Care Manual

INSTALLATION INSTALLATION
4
1. Drain port connecon
DRAIN HOSE:
2. Quick connect connecon
3. Inlet port connecon
INLET HOSE:
4. Quick connect connecon
5. Faucet adapter
FAUCET ADAPTER:
6. Faucet washer
QUICK CONNECT:
1. Pressure relief valve
2. Faucet adapter connecon
3. Locking collar
4. Inlet hose connecon
5. Drain hose connecon
NOTE: In order to avoid water staying in the inlet hose, close the faucet aer using it.
Ensure the voltage and frequency of the power being corresponds to those on the rang plate. Only
insert the plug into an electrical socket which is earthed properly.
1. Screw the faucet adapter onto the faucet tap. Check for leaks.
2. Connect the six-sided connecon of the drain hose to the drain port connecon on the back of the
dishwasher cabinet. Do not over-ghten (to avoid damage to threads).
3. Connect the star-shaped connecon of the inlet hose to the inlet port on the back of the dishwasher
cabinet. Do not over-ghten (to avoid damage to threads).
4. Connect the circular connecon of the drain hose onto the longer (boom) male connecon on
the quick connect.
5. Connect the circular connecon of the inlet hose onto the shorter (top) male connecon on the
quick connect.
6. Aach the quick connect onto the faucet adapter, by pulling down the outer locking collar on the
quick connect, while pushing the quick connect upward onto the faucet adapter.
7. When the quick connect snaps onto the faucet adapter, release the locking collar. Verify the
connecon is secure.
8. Slowly open the hot water line and check for any sign of water leaks at all hose connecons. If
leaks are located, immediately close the water supply and repair the hose connecons.
NOTE. Once you open the water supply line, (even if it is closed immediately thereaer), the inlet
hose will be pressurized. To relieve water pressure from inside the inlet hose, (make sure the water
line (faucet) is closed): press and hold the red pressure relief buon on the quick connect unl the
ow of water stops.