User Guide

Completing the Installation
3-24 Installation
Completing the Installation
CompletingtheDFE moduleinstallationdependsonifthemoduleisbeinginstalledin:
•anewDFE modulesystem(referto“CompletingtheInstallation”onpage 3‐24),or
•anestablished,operatingDFE modulesystem(referto“CompletingtheInstallation
ofaDFE‐GoldModuleinanExistingSystem”onpage 3‐26).
Completing the Installation of a New System
InanewsystemofDFE modules,oneoftheinstalledDFE moduleswillbecomethe
managementmoduleonchassispowerup,andallDFE moduleswillautomaticallybeset
tothefactorydefaultvalues.Acompletelistofthefactorydefaultvaluesareprovidedin
Chapter3oftheEnterasysMatrixDFE‐Gold
SeriesConfigurationGuide.
AfterinstallingallDFE modulesintothehostchassisandmakingtheconnectionstothe
network,proceedto“First‐TimeLog‐InUsingaConsolePortConnection”onpage 3‐25to
accessthemodulemanagementstartupscreenfromyourPC,terminal,ormodem
connection.
Modem Port Adapter Wiring and Signal Diagram
RJ45 DB25
Pin Conductor Pin Signal
1 Blue 2 Transmit (TX)
2 Orange 8 Data Carrier Detect (DCD)
4 Red 3 Receive
5 Green 7 Ground (GRD)
6 Yellow 20 Data Terminal Ready (DTR)
8 Gray 22 Ring Indicator
RJ45 Connector (Female)
81
Pins
DB25 Connector (Male)
131
Pins
14 25