User Guide

Completing the Installation
Matrix DFE-Gold Series PoE Module 4H4285-49 Installation Guide 3-25
First-Time Log-In Using a Console Port Connection
StarttheCommandLineInterface(CLI)fromthemodule’slocalconsoleportasfollows:
1. Connectaterminaltothelocalconsoleportasdescribedin“ConnectingtoCOMPort
forLocalManagement”onpage 3‐18.Thestartupscreen,Figure 3‐12,displays.
2. Attheloginprompt,enteroneofthefollowingdefault
usernames:
– roforRead‐Onlyaccess,
– rwforRead‐Writeaccess,or
– adminforSuperUseraccess.(ThisaccesslevelallowsRead‐Writeaccesstoall
modifiableparameters,includinguseraccounts.)
3. PressENTER.
4. ThePasswordpromptdisplays.LeavethisstringblankandpressENTER.The
moduleinformationandMatrixprompt
displaysasshowninFigure 3‐12.
TheDFE moduleisnowreadytobeconfigured.ForinformationaboutsettingtheIP
addressandconfiguringTelnetsettingsforremoteaccesstoDFE modulemanagement,
refertoChapter3intheEnterasysMatrixDFE‐GoldSeriesConfigurationGuide.The CLI
commandsenableyouto
initiallysetupandperformmoreinvolvedmanagement
configurations.
TheEnterasysMatrixDFE‐GoldSeriesConfigurationGuideisavailableonlineat:
http://www.enterasys.com /support/manuals
Ifyourequireassistance,contactEnterasysNetworksusingoneofthemethodsdescribed
in“GettingHelp”onpage xviii.
Note: This procedure applies only to initial log-in, and to logging in to a device not yet
configured with administratively-supplied user and password settings.
By default, the Matrix DFE Series device is configured with three user login accounts: ro
for Read-Only access; rw for Read-Write access; and admin for super-user access to all
modifiable parameters. The default password is set to blank (carriage return). For
information on changing these default passwords, refer to Chapter 3 in the
Enterasys
Matrix DFE-Gold Series Configuration Guide.