SmartSwitch User's Guide

IGMP/VLAN Configuration Screen
Layer 3 Extensions Menu Screens 10-7
10.2.1 IGMP/VLAN Configuration Procedure
To set up the IGMP protocol for each VLAN, proceed as follows:
1. Use the arrow keys to highlight the VLAN ID field, and use the SPACE bar to step through the
VLAN choices to find the correct VLAN to configure.
2. Use the arrow keys to highlight the IGMP State field.
VLAN ID
(Selectable)
See the Identifying number of the VLANs available to be modified. If
there are no VLANs available, NONE is displayed in this field and
asterisks (*) will display in the Configuration, Statistics, and IGMP
State fields. The information under Configuration and Statistics applies
only to this VLAN ID. Use the SPACE bar to step through all available
VLAN IDs.
The fields that are selectable or modifiable will initially display
asterisks (*), then the SPACE bar can be used to display the selectable
fields, and the numeric keys can be used to change the modifiable
fields.
To update the Configuration and Statistics fields for a selected
VLAN ID, use the SAVE command.
IGMP State
(Selectable)
See the current state of the VLAN indicated in the VLAN ID field,
which can be modified. Use the SPACE bar to step through the choices:
ENABLED, DISABLED, and DELETE. The commands will act only
on the VLAN whose ID is in the VLAN ID field.
NOTE: The VLAN IDs are those of the VLANs created using the Static VLAN
Configuration screen described in Chapter 8.
However, a VLAN ID of a VLAN not yet created can be entered, and the parameters can
be configured and saved using the SAVE command. However, the VLAN and its
configuration is not functional until that VLAN is created using the Static VLAN
Configuration screen. Parameters not modified default according to the MIB.
Table 10-2 IGMP/VLAN Configuration Screen Field Descriptions (Continued)
Use this field… To…