Ethernet Switch Owner's Manual

set port txq
Enterasys D-Series CLI Reference 12-7
Parameters
Defaults
Iftheport‐stringisnotspecified,theQoSsettingofallphysicalportswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
Thisexampleshows howtodisplaythecurrentalgorithmandtransmitqueueweightsconfigured
onport
ge.1.10:
D2(su)->show port txq ge.1.10
Port Alg Q0 Q1 Q2 Q3 Q4 Q5 Q6 Q7
----- --- --- --- --- --- --- --- --- ---
ge.1.10 WRR 10 10 15 20 25 20 0 0
set port txq
UsethiscommandtosetQoStransmitqueuearbitrationvaluesforphysicalports.
Syntax
set port txq port-string value0 value1 value2 value3 value4 value5 value6 value7
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
port‐string (Optional)Specifiesport(s)forwhichtodisplayQoSsettings.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 6‐1.
Onlyphysicalportswillbedisplayed.LAGportshavenotransmitqueue
information.
port‐string Specifiesport(s)onwhichtosetqueuearbitrationvalues.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
intheCLI”onpage 6‐1.
Onlyphysicalportscanbeconfiguredwiththiscommand.LAGports
cannotbeconfigured.
value0‐value7 Specifiespercentagetoallocate
toaspecifictransmitqueue.Thevalues
musttotal100percent.