Ethernet Switch Owner's Manual

Configuring Port Traffic Rate Limiting
12-10 Port Priority and Rate Limiting Configuration
Configuring Port Traffic Rate Limiting
Purpose
TolimittherateofinboundtrafficontheD‐Seriesdeviceonaperport/prioritybasis.The
allowablerangeforthe rate limitingis64ki lobytespersecondminimumuptothemaximum
transmissionrateallowableontheinterfacetype.
Ratelimitisconfiguredforagivenportandlist
ofpriorities.Thelistofprioritiescanincludeone,
some,oralloftheeight802.1pprioritylevels.Onceconfigured,therateofalltrafficenteringthe
portwiththeprioritiesconfiguredtothatportisnotallowedtoexceedtheprogrammedlimit.If
therateexceedstheprogrammedlimit,frames
aredroppeduntiltheratefallsbelowthelimit.
Commands
Thecommandstoconfiguretrafficratelimitingarelistedbelow.
show port ratelimit
Usethiscommandtoshowthetrafficratelimitingconfigurationononeormoreports.
Syntax
show port ratelimit [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,ratelimitinginformationwillbedisplayedforallports.
Mode
Switchcommand,read‐only.
For information about... Refer to page...
show port ratelimit 12-10
set port ratelimit 12-12
clear port ratelimit 12-13
port‐string (Optional)Displaysrate limitinginformationforspecificport(s).Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 4‐1.