Ethernet Switch Owner's Manual

Configuring IGMP at Layer 2
13-2 IGMP Configuration
multicastswitch/routeritpassesthroughtoensurethattrafficisonlypassedtothehoststhat
subscribedtothisservice.
Configuring IGMP at Layer 2
Purpose
ToconfigureIGMPsnoopingfromtheswitchCLI.
Commands
show igmpsnooping
UsethiscommandtodisplayIGMPsnoopinginformation.
Syntax
show igmpsnooping
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Usage
ConfiguredinformationisdisplayedwhetherornotIGMPsnoopingisenabled.Status
informationisdisplayedonlywhenthefunctionisenabled.ForinformationonenablingIGMPon
For information about... Refer to page...
show igmpsnooping 13-2
set igmpsnooping adminmode 13-3
set igmpsnooping interfacemode 13-3
set igmpsnooping groupmembershipinterval 13-4
set igmpsnooping maxresponse 13-5
set igmpsnooping mcrtrexpiretime 13-5
set igmpsnooping add-static 13-6
set igmpsnooping remove-static 13-7
show igmpsnooping static 13-7
show igmpsnooping mfdb 13-8
clear igmpsnooping 13-8