Network Hardware User's Manual

Memory Locations and Replacement Procedures
B-10 Mode Switch Bank Settings and Optional Installations
3. PulltheDRAMSIMMstraightupandremoveitfromtheconnector.
Installing the DRAM SIMM on 4H4203-72
ToinstalltheDRAMSIMM,refertoFigure B‐12andproceedasfollows:
1. PushtheconnectorarmsawayfromtheDRAMSIMMenoughtoinserttheDRAM
SIMMintotheconnectorfingers.
2. InserttheDRAMSIMMstraightdownbetweentheconnectorfingersenoughforthe
tabsontheconnectorarmstoalign
withthetwoDRAMSIMMalignmentnotches.
3. PushtheDRAMSIMMdownintothe connectorfingers.Thenrotatethetwo
connectorarmstowardtheDRAMSIMMtolockitintoplace.
Figure B-11 Removing Existing DRAM SIMM from 4H4203-72
1 Connector arms 2 Connector 3 DRAM SIMM
À
À
Á
Â
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.