Installation guide
Installation 3-1
3
Installation
This chapter provides the instructions to install the 5G102-06 and 5G106-06 modules. A Phillips
screwdriver is required to install options into the module. Follow the order of the sections listed
below to correctly install the module.
• Unpacking the Module (Section 3.1)
• Installing Options into the 5G106-06 (Section 3.2)
• Installing the Module into the 5C105 MATRIX E5 Chassis (Section 3.3)
• Connecting to the Network (Section 3.4)
• Completing the Installation (Section 3.7)
ELECTRICAL HAZARD: Only qualified personnel should install the module.
NOTE: Read the Release Notes shipped with the module to check for any exceptions to
the supported features and operation documented in this guide.