Installation guide

Connecting the 5G106-06 to the Network

Installation 3-17

Figure 3-12 Fiber GPIM Connections

3. At the other end of the fiber optic cable, attach the SC connector to the other device. Verify that

a link exists by checking that the port Receive LED is ON (flashing amber, blinking green, or

solid green). Refer to Chapter 4 for details on the LEDs. If the Receive LED is OFF and the

Transmit LED is not blinking amber, perform the following steps until it is ON:

a. Check that the device at the other end of the link has power turned on and is Gigabit Ethernet

compatible.

b. Verify proper crossover of fiber strands between the port on the module and the fiber optic

device at the other end of the fiber optic link segment.

c. Verify that the fiber optic cable meets the specifications outlined in Appendix C for the

installed GPIM.

SC Connector

GPIM-01, GPIM-08, or GPIM-09

3587_05

Key Latch (bottom of SC Connector)

(bottom view)

keys

SC Connector