Installation guide

Unpacking the Module
3-2
3.1 UNPACKING THE MODULE
Unpack the module as follows:
1. Open the box and remove the packing material protecting the module.
2. Verify the contents of the carton as listed in Table 3-1.
3. Remove the tape seal on the non-conductive bag to remove the module.
4. Perform a visual inspection of the module for any signs of physical damage. Contact Enterasys
Networks if there are any signs of damage. Refer to “Getting Help” in About This Guide for
details.
5. If you are installing an optional 5PIM in the module, the 5PIM must be installed before
installing the module into the E5 chassis. To install the 5PIM, proceed to Section 3.2 for
instructions.
Table 3-1 Contents of Module Carton
Item Quantity
One module, either the 5H152-50 or the 5H153-50 1
Antistatic Wrist Strap 1
Manual Accessory Kit 1