User`s guide

Release Notes Known Issues With This Release
Release 3.5 Enhanced Support for VPN Clients
Rel. 3.5 Release Notes Page 29 of 30
Since IPSec default values were removed from the APS database, Floppy
Configuration does not run correctly. To set these defaults, you must run the
ipsecDefault script using the CLI on the remote ANG receiving the
configuration via a floppy disk.
CAUTION
This script first erases all IPSec configuration settings and then reloads it
with the factory default. Any configurations you added earlier are lost.
As a precaution against inadvertent use of the command, the script
interactively prompts you to confirm that you intend to erase and then
restore the initial IPSec configuration.
To issue the ipsecDefault command, perform the following:
1 Log into the ANG-3000/7000 with the login and password netadmin
(default) and press
ENTER.
2 Load the floppy disk in the ANG-3000/7000’s floppy disk drive.
3 Reboot the ANG-3000/7000.
The ANG copies the configuration file to its hard drive.
4 At the command prompt, change directory to usr/indus/ipsec.
5 Type ipsecDefault and press
ENTER.
6 Reboot the ANG-3000/7000.
Upon completing the reboot, the ANG will resume normal tunnel
operation.
For more information, refer to the Application Note: ANG Configuration Using
the Command Line Interface. Bug # 3671:
! EAP Authentication for PPTP Controlled in L2TP Window
The EAP authentication protocol is supported by PPTP and L2TP but is
controlled from the L2TP configuration tab on RiverMaster. The use of EAP in
PPTP is controlled by the EAP radio button under L2TP. Bug # 3675.