User`s guide

Enabling LACP Flow Regeneration
Matrix DFE Series and N-SA User’s Guide 4-7
To set the actor or partner administrative states:
set port lacp port port-string aadminstate | padminstate {lacpactive |
lacptimeout | lacpagg | lacpsync | lacpcollect | lacpdist | lacpdef |
lacpexpire}
Adminstateparametersallowforactororpartnerportstoperformasfollows:
• lacpactive‐TransmitLACPPDUs.
• lacptimeout‐TransmitLACPPDUsevery1secondversus30seconds(default).
• lacpagg‐Aggregateonthisport.
• lacpsync‐Transitiontosynchronizationstate.
• lacpcollect‐Transitiontocollectionstate.
• lacpdist‐Transition
todistributionstate.
• lacpdef‐Transitiontodefaultedstate.
• lacpexpire‐Transitiontoexpiredstate.
Enabling LACP Flow Regeneration
TheflowregenerationfunctionontheMatrixDFESeriesorN‐SAdeviceallowsLACPto
redistributeallexistingflowsoveralinkaggregationgroupwhenanewportjoinstheLAG.Flow
regenerationwillalsoattempttoloadbalanceexistingflowstotakeadvantageofportsaddedto
theLAG.
Bydefault,flowregenerationisdisabledonthedevice.Thismeansthatwhenanewport
joinsaLAG,LACPwillonlydistributenewflowsovertheincreasednumberofports intheLAG
andwillleaveexistingflowsintact.
UsethiscommandtoenableLACPflowregeneration:
set lacp flowRegeneration enable