Installation guide

Matrix DFE-Diamond Series Installation Guide B-1
B
Mode Switch Settings and Installing Options
Thisappendixcoversthefollowingitems:
Required Tools
Usethefollowingtoolstoperformtheproceduresprovidedinthisappendix:
•Antistaticwriststrap
• Phillipsscrewdri ver
Setting the Mode Switches
Figure B‐3throughFigure B‐5showthelocationofthemodeswitchesandtheswitchsettingsfor
normaloperation.Theseswitchesaresetatthefactoryandrarelyneedtobechanged.
Switchdefinitionsandpositionsareasfollows:
•Switches1through6–ForEnterasys Networksuseonly.
For information about... Refer to page...
Required Tools B-1
Setting the Mode Switches B-1
Memory Locations and Replacement Procedures B-3
Caution: An antistatic wrist strap is required to perform the procedures in this appendix. Use the
antistatic wrist strap to minimize ESD damage to the devices involved.
Precaución: Para llevar a cabo los procedimientos especificados en el apéndice deberá utilizar
una pulsera antiestática. Esta pulsera sirve para minimizar los efectos de las descargas de
electricidad estática.
Caution: Read the appropriate sections to be fully aware of the consequences when changing
switch settings.
Only qualified personnel should change switch settings.
Precaución: Si desea modificar la configuración del interruptor, lea las secciones correspondientes
para saber cuál será el resultado de hacerlo.
Estas modificaciones a la configuración sólo debe realizarlas personal calificado.