Installation guide

Memory Locations and Replacement Procedures

B-8 Mode Switch Settings and Installing Options

Figure B-10 Removing the Existing DIMM

3. RotatetheDIMMupwards,thenremoveitfromtheconnectorfingers.

Installing the DIMM

ToinstallaDIMM,refertoFigure B‐11andproceedasfollows:

1. InserttheDIMMdownbetweentheconnectorfingers.

2. PivottheDIMMdownwardsothetabsontheconnectorarmsalignwiththetwoDIMM

alignmentnotches.Withthetwoconnectorarmsspreadoutward,pushtheDIMMdown

betweentheconnector

arms.ThenreleasethetwoconnectorarmstolocktheDIMMinto

place.

3. Ifnecessary,reinstalltheNEM.RefertotheinstallationinstructionsshippedwiththeNEMfor

details.

Figure B-11 Installing the DIMM

1 Connector arms 2 DIMM 3 Connector fingers

Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive

electronic equipment.

Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones de

seguridad para evitar descargas de electricidad estática.

1 DIMM 3 Connector arms

2 Connector fingers 4 DIMM alignment notches (2)